KIDD Threaded
Receiver Pins — secure your trigger group and eliminate loose pins for good.
What makes it special
·
Prevents trigger guard pins from falling out
when removing the barreled action
·
Designed specifically for KIDD .22LR receivers but can be fitted to
most 10/22®-style receivers
·
Threaded screws lock the trigger group in place
for a stable, service-ready setup
·
Clean, flush fit when used with an 82° countersink on non-KIDD receivers
Key specs
·
Includes two
threaded receiver pins, four screws, and needed short arm
wrenches
·
Material: precision-machined steel hardware
·
Designed for KIDD receivers; compatible with
standard 10/22® receivers with proper countersinking
·
Retains trigger assembly during maintenance or
stock changes
Avoiding lost pins — our engineering
Traditional 10/22® cross pins can slide out easily during disassembly, often
sending the trigger group to the floor. KIDD’s threaded receiver pin system
eliminates that problem entirely. The threaded screws clamp to each side of the
receiver, keeping the trigger assembly secure even when the barreled action is
out of the stock. When upgrading a non-KIDD receiver, a simple 82° countersink ensures the screws sit
flush and clean.
Installation & break-in tips
·
KIDD receivers come ready for these pins
·
For non-KIDD receivers, countersink each pin
hole to 82° so screws seat flush
·
With screw on one end insert each pin through
the aligned trigger and receiver holes
·
Install the second screw on each pin using the
included hex wrenches
·
Tighten finger
tight only—do not apply excess torque
·
Verify smooth trigger unit alignment after
installation
